|
Post by Lucid on May 8, 2007 20:52:30 GMT -5
My dad has an 86 Carb LG4 5 Speed Camaro and the computer went bad. I looked all over and finally found an ECM in an 86 Monte Carlo with matching 1227169 GM part number on it.
How do i remove the PROM from the ECM to swap it over to the new one? This ECM design is not a TPI so there is no memcal looking thingy. Its a long chip thats soldered into place and next to it, theres a PROM in a black plastic carrier i believe.
Do i need a PROM removal tool to do this?
|
|
|
Post by Lucid on May 8, 2007 23:04:24 GMT -5
Got it!
The PROM carrier surrounds the pins on the actual prom itself so that you dont bend them. A good FIRM rocking motion back and forth pops it right out.
|
|